1
Cut a drawer front too short on a big kitchen job in Phoenix
I was fitting the last drawer for a maple vanity and realized I was a quarter inch short on the width. The client was coming the next day and I had no extra wood from that batch. I ended up cutting a thin strip from the back edge of the drawer box itself and gluing it to the front, then re-cutting the box joint. It blended perfectly after sanding and finishing. Has anyone else saved a piece this way when you're out of matching material?
3 comments
Log in to join the discussion
Log In3 Comments
ivan_murphy8022d ago
Man, that's a solid save. Did you ever have a time where you had to get even more creative? I once had to fix a cabinet door where the edge chipped bad right before install. No spare plywood left at all. I ended up mixing sawdust from sanding that same door with some clear epoxy to make a filler paste. It dried super hard, sanded down smooth, and took the stain almost perfectly. You could only see it if you knew exactly where to look. I mean, sometimes you just have to use whatever is on the truck to make it work.
8
viola_lopez3022d ago
My uncle swears by that sawdust trick for small wood repairs. What's the biggest chip you've ever fixed like that?
1